Why Buyers Choose Tai Phat Precision
You are an engineer or a buyer looking for a machining supplier. Below is what we're actually good at, and what we're not — so you can decide quickly.
We hold ±0.01 mm as standard, not as a best case.
±0.005 mm is available where the part needs it, agreed at quote stage rather than discovered later.
We measure in-house.
CMM, vision system and surface roughness tester in our own metrology room — no waiting on an outside lab, and no delay when a dimension is queried.
High-mix is our normal.
21 machines across turning and milling means a mixed order gets split across machines instead of queued behind one long run.
We design the fixture when the part needs one.
In-house engineering in Siemens NX, machined in the same workshop, for workholding and for our customers' assembly lines.
One point of contact through finishing.
Grinding, wire EDM and laser cutting are done in-house; anodising, plating and heat treatment are coordinated by us and inspected on return.
We answer.
Quotes typically in 48–72 hours.
We're a ~1,500 m² shop, not a mass-production plant. If your part needs 5-axis simultaneous machining, in-house anodising, or a million pieces a month, we'll tell you straight away and you'll have lost nothing but one email.
Have a Drawing? Get a Quote.
Send us your technical drawing and we'll come back with a clear, fast quote.